Decorative Line

Quartz System

Epoxy Quartz Systems provide the right balance between aesthetics and durability. Like the manufacturing industrial systems, it is installed at a higher mil thickness, capable of meeting a number of production demands. Use the EPOXY HIGH CLEAR as both the base coat and top coat while broadcasting the aggregate. It is recommended to use UV INHIBITORS, a urethane finish, or substitute the top coat for a polyaspartic to provide UV resistance and improve long term aesthetics.

The ONYX Quartz System should be installed in one of the following ways:

1. EPOXY HIGH CLEAR UV at 100 SF p/g through squeegee/rolling and broadcasting ½ lb. per SF of aggregate to achieve 50 mils. Repeat this step as a double broadcast to achieve 100 mils. For the top coat, either (a) apply EPOXY HIGH CLEAR at 80-100 SF p/g, then apply 2K CRU WB polyurethane finish coat at 400 SF p/g, or (b) apply one of the Polyaspartics as the top coat at 80-100 SF p/g.
2. EPOXY HIGH CLEAR UV at 50 SF p/g through troweling and broadcasting 1 lb. per SF of quartz aggregate to achieve 100 mils, hereby eliminating the step for a second broadcast without jeopardizing thickness. (Note: this is an advanced technique not to be taken lightly.) (Make sure to add a little aggregate while mixing the two components to help trowel, while keeping the mix wet.) For the top coat, either (a) apply EPOXY HIGH CLEAR at 80-100 SF p/g, then apply the 2K CRU WB polyurethane finish coat at 400 SF p/g, or (b) apply one of the Polyaspartics as the top coat at 80-100 SF p/g.
3. Epoxy Prime Base (in one of three speeds) or Epoxy WB Fast 400 SF for a primer coat. Then apply one of the Polyaspartics at 100 SF p/g through squeegee/rolling and broadcasting ½ lb. per SF of aggregate to achieve 50 mils. Repeat this step as a double broadcast to achieve 100 mils. For the top coat, apply one of the Polyaspartics at 80-100 SF p/g.

General Notes

• Each of the products come in slow and fast versions. Be mindful of the total SF of the project if using fast cure products.
• The ONYX Quartz System should be a minimum of 100 mils thick. 50 mil systems are not recommended as it may not provide enough hide, as may be shown through an onsite mockup.
• For a 100 mil thick floor, the base coat should be 100 SF p/g (two broadcasts) or 50 SF p/g (single broadcast). To achieve 1/8″ (125 mils), the base coat should be 80 SF p/g (two broadcasts) or 40 SF p/g (single broadcast).
• A double broadcast does better at hiding imperfections (e.g., cracks and spalls) over damaged concrete by creating a more flat and even surface.
• Apply the top coat at 100 SF p/g for a textured surface, and 80 SF p/g for smooth.
• For exterior projects, select option (3) for better UV resistance.
• All coverage rates are nominal as concrete conditions vary (integrity of the substrate, high/low spots, etc.)

Wet Environments

If installing a quartz system in a wet environment (e.g., kitchen), particularly with hot temperatures, the Hybrid System is recommended.

Recommended Areas for usage:

• Pharmaceutical
• Lunchrooms
• Laboratories
• Veterinary Clinics
• Locker Rooms
• Hospitals / Hotels
• Schools
• Kitchens (Hybrid Recommended)
• Restrooms
• Clean Rooms